Carrier Access Network Device Axxius 800 Manuale Utente Pagina 436

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 568
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 435
13-6 Axxius 800 - Release 2.2
Quad DS1 ADPCM Card
Card Configuration
Card Configuration
All options on the this Service card are set using the Command Line Interface (CLI).
CLI Commands
The following commands are used to configure the Quad DS1 ADPCM card. For
detailed information on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels.
l disconnect
Removes a connection created by the connect command.
l set (ds1 card) adpcm map
Sets the voice compression map on the ADPCM card (none, map 1, map 2
or map 3).
l set (ds1)
Sets up the DS1 interfaces (clock, up, down, fdl, framing, id string, lbo, line,
linecode, loopdetect).
l set lsbackup
Defines the backup protection slot.
l set lsprotect enable/disable
Enables or disables the Low Speed Protection options on the system.
l set lsprotect manual
Sets the manual mode control for protected ports.
l set lsprotect nonrevertive
Defines the port non-revertive status and priority level.
l set lsprotect remove
Removes port from protected mode.
l set lsprotect revertive
Defines the port revertive status and priority level.
Vedere la pagina 435
1 2 ... 431 432 433 434 435 436 437 438 439 440 441 ... 567 568

Commenti su questo manuale

Nessun commento